IQ24280HEC14 Datasheet, PDF (1/12 Pages) SynQor Worldwide Headquarters – Half-brick DC-DC Converter

Technical
Specification
IQ24280HEC14
18-36 V 28 V
Input
Output
14 A
Current
2250 Vdc
Isolation
Half-brick
DC-DC Converter
The IQ24280HEC14 InQor^™ Exa converter is an iso-
lated, fixed switching frequency DC-DC converter that
uses synchronous rectification to achieve extremely high
efficiency and power density. The 24 Vin modules fea-
ture 2,250 Vdc isolation and low common mode noise.
The Exa series converters offer industry leading useable
output power for any standard “half-brick” module.
RoHS compliant (see last page).
Operational Features
• Ultra-high efficiency, 93% at full rated load current,
95% at half rated load current
• Delivers up to 14 A of output current (392 W)
• Wide input voltage range: 18 – 36 V, with 50 V 100
ms input voltage transient capability
• Fixed frequency switching provides predictable EMI
performance
• No minimum load requirement means no preload resis-
tors required
• Wide output voltage trim range (-50% to +20%), see
trim section
Mechanical Features
• Industry standard half-brick pin-out configuration
• Brick size: 2.39" x 2.49" (63.1 x 60.6 mm)
• Total height only 0.512" (13 mm)
• Total weight: 4.3 oz. (123 grams)
Control Features
• On/Off control referenced to input side
IQ24280HEC14 Module
Protection Features
• Input under-voltage lockout disables converter at low
input voltage conditions
• Output current limit and short circuit protection protects
converter and load from damage and consequent haz-
ardous conditions
• Active back bias limit provides smooth startup with
external load induced pre-bias
• Latching output over-voltage protection protects load
from damaging voltages
• Thermal shutdown protects converter from abnormal
environmental conditions
Safety Features
• 2250 V, 30 MW input-to-output isolation provides
input/output ground separation
• UL/cUL 60950-1 recognized (US & Canada), basic
insulation rating
• TUV certified to EN60950-1
• Meets 72/23/EEC and 93/68/EEC directives which
facilitates CE Marking in user’s end product
• Board and plastic components meet UL94V-0 flammabil-
ity requirements
Product # IQ24280HEC14
Phone [phone]
www.synqor.com
Doc.# 005-IHE2428 Rev. B
09/19/08
Page 1