English
Language : 

HV5308 Datasheet, PDF (2/6 Pages) Supertex, Inc – 32-Channel Serial To Parallel Converter With High Voltage Push-Pull Outputs
Electrical Characteristics (VPP = 60V, VDD = 12V, TA =25°C)
DC Characteristics
Symbol
Parameter
Min
Max
IPP
VPP Supply Current
0.5
IDDQ
IDD Supply Current (Quiescent)
100
IDD
IDD Supply Current (Operating)
15
Units
mA
µA
mA
VOH (Data)
VOL (Data)
IIH
IIL
VOC
VOH
VOL
VOH
VOL
Shift Register Output Voltage
Shift Register Output Voltage
Current Leakage, any input
Current Leakage, any input
HV Output Clamp Diode Voltage
HV Output when Sourcing
HV Output when Sinking
HV Output when Sourcing
HV Output when Sinking
10.5
V
1
V
1
µA
-1
µA
-1.5
V
52
V
8
V
52
V
8
V
AC Characteristics
Symbol
Parameter
fCLK
tWL or tWH
tSU
tH
tDLH (Data)
tDHL (Data)
tDLE
tWLE
tSLE
tON
tOFF
Clock Frequency
Clock width, HIGH or LOW
Setup time before CLK rises
Hold time after CLK rises
Data Output Delay after L to H CLK
Data Output Delay after H to L CLK
LE Delay after L to H CLK
Width of LE Pulse
LE Setup Time before L to H CLK
Delay from LE to HVOUT, L to H
Delay from LE to HVOUT, H to L
Min
Max
Units
8
MHz
62
ns
25
ns
10
ns
110
ns
110
ns
50
ns
50
ns
50
ns
500
ns
500
ns
HV5308/HV5408
Conditions
HVoutputs HIGH to LOW
All inputs = VDD or GND
VDD = VDD max,
fCLK = 8 MHz
IO = 100µA
IO = 100µA
VIN = VDD
VIN = 0
IOL = -100mA
IOH = -20mA, -40 to 85°C
IOL = 20mA, -40 to 85°C
IOH = -15mA, -55 to 125°C
IOL = 15mA, -55 to 125°C
Conditions
CL = 15pF
CL = 15pF
Recommended Operating Conditions
(over -40 to 85°C for plastic and -55°C to 125°C for ceramic)
Symbol
Parameter
Min
Max
VDD
Logic Voltage Supply
10.8
13.2
VPP
High Voltage Supply
8.0
80
VIH
Input HIGH Voltage
VDD-2
VDD
VIL
Input LOW Voltage
0
2
fCLK
Clock Frequency
0
8
Note:
Power-up sequence should be the following:
1. Connect ground.
2. Apply VDD.
3. Set all inputs (Data, CLK, LE, etc.) to a known state.
4. Apply VPP.
5. The VPP should not fall below VDD or float during operation.
Power-down sequence should be the reverse of the above.
2
Units
V
V
V
V
MHz