TP5335 Datasheet, PDF (1/2 Pages) Supertex, Inc – P-Channel Enhancement-Mode Vertical DMOS FETs

TP5335
Low Threshold
Product Objective Specification
P-Channel Enhancement-Mode
Vertical DMOS FETs
Ordering Information
BV_DSS /
BV_DGS
-350V
R_DS(ON)
(max)
30Ω
V_GS(th)
(max)
-2.4V
Order Number/Package
TO-236AB*
Wafer
TP5335K1 TP5335NW
*Same as SOT-23. All units shipped on 3,000 piece carrier tape reels.
Product marking for SOT-23
P3S❋
Where *=2-week alpha date code
Features
Free from secondary breakdown
Low power drive requirement
Ease of paralleling
Low C_ISS and fast switching speeds
Excellent thermal stability
Integral Source-Drain diode
High input impedance and high gain
Complementary N- and P-channel devices
Applications
Logic level interfaces – ideal for TTL and CMOS
Solid state relays
Analog switches
Power Management
Telecom switches
Advanced DMOS Technology
These enhancement-mode (normally-off) transistors utilize a
vertical DMOS structure and Supertex’s well-proven silicon-gate
manufacturing process. This combination produces devices with
the power handling capabilities of bipolar transistors and with the
high input impedance and positive temperature coefficient inher-
ent in MOS devices. Characteristic of all MOS structures, these
devices are free from thermal runaway and thermally-induced
secondary breakdown.
Supertex’s vertical DMOS FETs are ideally suited to a wide range
of switching and amplifying applications where high breakdown
voltage, high input impedance, low input capacitance, and fast
switching speeds are desired.
Package Options
Drain
Absolute Maximum Ratings
Drain-to-Source Voltage
Drain-to-Gate Voltage
Gate-to-Source Voltage
Operating and Storage Temperature
Soldering Temperature*
* Distance of 1.6 mm from case for 10 seconds.
BV_DSS
BV_DGS
± 20V
-55°C to +150°C
300°C
Gate
Source
TO-236AB
(SOT-23)
top view
Note: See Package Outline section for dimensions.
11/12/01
Supertex Inc. does not recommend the use of its products in life support applications and will not knowingly sell its products for use in such applications unless it receives an adequate "products liability
indemnification insurance agreement." Supertex does not assume responsibility for use of devices described and limits its liability to the replacement of devices determined to be defective due to
workmanship. No responsibility is assumed for possible omissions or inaccuracies. Circuitry and specifications are subject to change without notice. For the latest product specifications, refer to the
Supertex website: http://www.supertex.com. For complete liability information on all Supertex prod₁ucts, refer to the most current databook or to the Legal/Disclaimer page on the Supertex website.