HV9708 Datasheet, PDF (1/5 Pages) Supertex, Inc – 32-Channel Serial To Parallel Converter With High Voltage Push-Pull Outputs

HV9708
HV9808
32-Channel Serial To Parallel Converter
With High Voltage Push-Pull Outputs
Ordering Information
Package Options
Device
44 J-Lead Quad
Plastic Chip Carrier
Die
in waffle pack
HV9708
HV9808
HV9708PJ
HV9808PJ
HV9708X
HV9808X
Features
❏ Processed with HVCMOS^® technology
❏ Output voltages up to 80V
❏ Low power level shifting
❏ Shift register speed 8MHz
❏ Latched data outputs
❏ Forward and reverse shifting options
❏ Diode to V_PP allows efficient power recovery
❏ 5V CMOS compatible inputs
Absolute Maximum Ratings¹
Supply voltage, V_DD2
Output voltage, V_PP2
Logic input levels²
Ground current³
-0.5V to +7V
V_DD to +90V
-0.5V to V_DD +0.5V
1.5A
Continuous total power dissipation⁴
1200mW
Operating temperature range
-40°C to +85°C
Storage temperature range
-65°C to +150°C
Lead temperature 1.6mm (1/16 inch)
from case for 10 seconds
260°C
Notes:
1. Device will survive (but operation may not be specified or guaranteed) at
these extremes.
2. All voltages are referenced to GND.
3. Duty cycle is limited by the total power dissipated in the package.
4. For operation above 25°C ambient, derate linearly to 70°C at 12mW/°C.
General Description
The HV97 and HV98 are low-voltage serial to high-voltage paral-
lel converters with push-pull outputs. These devices have been
designed for use as drivers for AC-electroluminescent displays.
They can also be used in any application requiring multiple output
high-voltage current sourcing and sinking capabilities such as
driving plasma panels, vacuum fluorescent displays, or large
matrix LCD displays. The inputs are fully CMOS compatible.
These devices consist of a 32-bit shift register, 32 latches, and
control logic to perform the polarity select and blanking of the
outputs. HV_OUT1 is connected to the first stage of the shift register
through the polarity and blanking logic. Data is shifted through the
shift register on the logic low to high transition of the clock. The
HV97 shifts data in the clockwise direction when viewed from the
top of the package and the HV98 shifts in the counterclockwise
direction. A data output buffer is provided for cascading devices.
This output reflects the current status of the last bit of the shift
register (HV_OUT32). Operation of the shift register is not affected
by the LE (latch enable), BL (blanking), or the POL (polarity) in-
puts. Transfer of data from the shift register to the latch occurs
when the LE (latch enable) input is high. The data in the latch is
stored when LE is low.
02/96/022
Supertex Inc. does not recommend the use of its products in life support applications and will not knowingly sell its products for use in such applications unless it receives an adequate "products liability
indemnification insurance agreement." Supertex does not assume responsibility for use of devices described and limits its liability to the replacement of devices determined to be defective due to
workmanship. No responsibility is assumed for possible omissions or inaccuracies. Circuitry and specifications are subject to change without notice. For the latest product specifications, refer to the
Supertex website: http://www.supertex.com. For complete liability information on all Supertex prod₁ucts, refer to the most current databook or to the Legal/Disclaimer page on the Supertex website.