|
CL7 Datasheet, PDF (1/4 Pages) Supertex, Inc – Linear, 100mA, Constant Current LED Driver with Enable | |||
|
CL7
Linear, 100mA, Constant Current
LED Driver with Enable
Features
⺠100mA ±5% constant current drive
⺠Built-in reverse polarity protection
⺠Logic level enable
⺠Dimmable via EN pin
⺠Overtemperature protection
⺠90V max rating for transient immunity
Applications
⺠Flashlights
⺠Specialty lighting
⺠Low voltage signage
⺠Low voltage lighting
⺠This device is not rated for automotive applications!
General Description
The CL7 is a linear ï¬xed current regulator designed for
driving high brightness LEDs at 100mA from nominal 12V,
24V, and 48V power supplies. With a maximum rating of
90V, it is able to withstand transients without the need for
additional transient protection circuitry. The CL7 is offered
in the Power SO-8 package.
An active low enable input (EN) allows logic level control
of the LED for on/off control or PWM dimming. The enable
input has 100kΩ pull-down resistance. For applications not
needing an enable input, refer to the CL6 data sheet.
Overtemperature protection shuts off the LED current
when the die temperature rises above 135°C (nominal).
Full LED current resumes when the die temperature falls
below 105°C (nominal).
Typical Application Circuit
VIN
Host
Controller
100mA
VDD
EN
Control
100kΩ
CL7
OUT
GND
|
▷ |