|
SGS Datasheet, PDF (1/2 Pages) Surge Components – Standard, Long life down size and high ripple current | |||
|
ALUMINUM ELECTROLYTIC CAPACITORS
SGS Series
ï¬ Standard, Long life down size and high ripple current.
ïµ SPECIFICATIONS
Item
Category Temperature Range
Working Voltage Range
Capacitance Range
Capacitance Tolerance
Performance Characteristics
-25 ~ +85â
200 ~ 450Vdc
68 ~ 2,200 μF
±20% (at 25â and 120Hz)
Dissipation Factor
(tanδ)
(at 25â, 120Hz)
Rated Voltage (V) 200
220
250
400
420
450
tanδ(Max)
0.20 0.20 0.20 0.20 0.20 0.20
The above value should be increased by 0.02 for every additional 1000μF
Leakage Current
I=0.02CV or 3000μA,whichever is smaller
I : Leakage current (μA) C : Rated capacitance (μF) V : Rated voltage (V)
Impress the rated voltage for 5 minutes.
Endurance
The following requirements shall be satisfied when the capacitor are restored to 25â after the rated voltage applied
for 3,000 hours at 85â.
Capacitance change
⦠±20% of the initial value
Dissipation factor(tanδ)
⦠200% of the specified value
Leakage current
⦠specified value
Shelf Life
The following requirements shall be satisfied when the capacitor are restored to 25â after exposing them for 1,000
hours at 85â without voltage applied.
Capacitance change
⦠±20% of the initial value
Dissipation factor(tanδ)
⦠200% of the specified value
Leakage current
⦠200% of the specified value
Others
ïµ DIMENSIONS (mm)
Terminal Code : ND : Standard
Sleeve
Negative mark
Safety vent
L+2 Max
4.0 ¡ Ã0.5
+
-
Conforms to JIS-C-5101-4 (1998), characteristic W.
PC board Pin-out
10¡ Ã0.5
2- 2
Terminal Code :K6 (ø35)
Sleeve
Vent
L+2 Max
*A
6.3±1.0
PC board pin-out
60¡ã
60¡ã
B
*C
-
Terminal B=positive
4- 2
Terminal A&C=blank
ïµ PART NUMBERING SYSTEM( Example : 250V 560µF )
S G S 2 E 5 6 1 MND 2 2 5 0
Special Request
Size code(2250 : 22Ã50)
Terminal length code
Lead forming Type code
Capacitance tolerance code(M:±20%)
Capacitance code(560μF)
Voltage code(250V)
Series code (SGS)
|
▷ |