KBPC25005W Datasheet, PDF (1/2 Pages) Dc Components – TECHNICAL SPECIFICATIONS OF SINGLE-PHASE SILICON BRIDGE RECTIFIER

KBPC25005W-KBPC2510W
SINGLE-PHASE SILICON BRIDGE RECTIFIER
VOLTAGE RANGE: 50 - 1000V
CURRENT: 25 A
Features
D Diffused Junction
D Low Reverse Leakage Current
D Low Power Loss, High Efficiency
D Surge Overload Rating to 400A Peak
D High Case Dielectric Strength of 1500VRMS
Mechanical Data
D Case: High Conductivity Matal
D _Terminals: Plated Leads Solderable per
MIL-STD-202,Method 208
D Polarity: Symbols Marked on Case
D Mounting: _{Through Hole for #10 Screw}
D MountingTorque: 8.0 Inch-pounds Maximum
D Mounting Position : Any
D Marking : Type Number
KBPC-25W
0.452 _MAX.
(11.5)
0.042(1.10) DIA.
0.038(0.97)
0.591 _MAX.
(15.0)
0.732(18.6)
0.692(17.6)
1.181(30.0)
1.102(28.0)
0.673(17.1)
0.633(16.1)
AC
+
-
AC
HOLE FOR
NO.8 SCREW
1.181(30.0)
1.102(28.0)
0.468(11.9)
0.429(10.9)
0.732(18.6)
0.692(17.6)
0.033x.250
(0.8x6.4)
Dimensions in inches and (millimeters)
Maximum Ratings and Electrical Characteristics T_A = 25°C unless otherwise specified
Single phase, half wave, 60Hz, resistive or inductive load. For capacitive load, derate current by 20%.
Characteristic
Symbol
KBPC
25005W
KBPC
2501W
KBPC
2502W
KBPC
2504W
KBPC
2506W
Maximum repetitive peak reverse voltage
VRRM _{50 100 200 400 600}
Maximum RMS voltage
VRMS
35
70 140 280 420
Maximum DC blocking voltage
VDC
50
100 200 400 600
Maximum average forward output rectified
current at TC=50 C (Note 1,2)
I(AV)
25
Peak forward surge current
8.3ms single half sine-wave superimposed on
IFSM
rated load (JEDEC Method)
300.0
Rating for Fusing(t<8.3ms)
I²t
373
Maximum instantaneous forward voltage dorp
per bridge element at 12.5A
VF
1.1
Maximum DC reverse current TA=25 C
IR
at rated DC blocking voltage TA=100 C
Isolation voltage from case to leads
VISO
Typical Thermal Resistance (Note 2)
RθJA
Operating junction temperature range
TJ
storage temperature range
TSTG
10
1.0
2500
2.0
-65 to +150
-65 to +150
NOTES:
1.Unit mounted on 5” x6” x4.9” thick(12.8cmx15.2cmx12.4cm)Al.plate.
2.Bolt dowm on heat-sink with silicone thermal compound between bridge and mounting surface for
maximum heat transfer efficiency with #8 screw.
KBPC
2508W
800
560
800
KBPC
2510W
1000
700
1000
Unit
V
V
V
A
A
A²s
V
µA
mA
VAC
C/W
C
C
1 of 2
www.sunmate.tw