KBPC15005W Datasheet, PDF (1/2 Pages) Dc Components – TECHNICAL SPECIFICATIONS OF SINGLE-PHASE SILICON BRIDGE RECTIFIER

VOLTAGE RANGE: 50 - 1000V
CURRENT: 15.0 A
Features
! Glass Passivated Die Construction
! Low Reverse Leakage Current
! _{Low Power Loss, High Efficiency}
! Electrically Isolated Epoxy Case for
! Maximum Heat Dissipation
Mechanical Data
! Case: Epoxy Case with Heat Sink Internally
Mounted in the Bridge Encapsulation
! Terminals: Plated Leads Solderable per
MIL-STD-202, Method 208
! Polarity: Symbols Marked on Case
! Mounting: Through Hole for #10 Screw
! Marking: Type Number
KBPC15005W-KBPC1510W
SILICON BRIDGE RECTIFIERS
KBPC-15W
0.452 _MAX.
(11.5)
0.042(1.10) DIA.
0.038(0.97)
0.591 _MAX.
(15.0)
0.732(18.6)
0.692(17.6)
1.181(30.0)
1.102(28.0)
0.673(17.1)
0.633(16.1)
AC
+
-
AC
HOLE FOR
NO.8 SCREW
1.181(30.0)
1.102(28.0)
0.468(11.9)
0.429(10.9)
0.732(18.6)
0.692(17.6)
0.033x.250
(0.8x6.4)
Dimensions in inches and (millimeters)
Maximum Ratings and Electrical Characteristics T_A = 25°C unless otherwise specified
Single phase, half wave, 60Hz, resistive or inductive load. For capacitive load, derate current by 20%.
Characteristic
Maximum repetitive peak reverse voltage
Maximum RMS voltage
Maximum DC blocking voltage
Maximum average forward output rectified
current at TC=55 C (Note 1,2)
Peak forward surge current
8.3ms single half sine-wave superimposed on
rated load (JEDEC Method)
Rating for Fusing(t<8.3ms)
Maximum instantaneous forward voltage dorp
per bridge element at 7.5A
Maximum DC reverse current TA=25 C
at rated DC blocking voltage TA=100 C
Isolation voltage from case to leads
Typical Thermal Resistance (Note 2)
Operating junction temperature range
storage temperature range
Symbol
KBPC
15005W
KBPC
1501W
KBPC
1502W
KBPC
1504W
KBPC
1506W
KBPC
1508W
KBPC
1510W
Unit
VRRM
50
100 200 400 600 800 1000 ^VOLTS
VRMS
35
70 140 280 420 560 700 ^VOLTS
VDC
50
100 200 400 600 800 1000 ^VOLTS
I(AV)
15
Amps
IFSM
I²t
VF
IR
VISO
RθJA
TJ
TSTG
300.0
373
1.1
10
1.0
2500
2.0
-65 to +150
-65 to +150
Amps
A²s
Volts
µA
mA
VAC
C/W
C
C
NOTES:
1.Unit mounted on 5” x 4” x3” thick(12.8cmx10.2cmx7.3cm)Al.plate.
2.Bolt dowm on heat-sink with silicone thermal compound between bridge and mounting surface for
maximum heat transfer efficiency with #8 screw.
1 of 2
www.sunmate.tw