|
SMM153_10 Datasheet, PDF (1/18 Pages) Summit Microelectronics, Inc. – 10-bit Digital Differential Voltage and Current Monitor | |||
|
SMM153
10-bit Digital Differential Voltage and Current Monitor
FEATURES & APPLICATIONS
INTRODUCTION
⢠Real-time power monitoring for âGreenâ systems
⢠Differential Voltage Sensing of the DC-DC converter
output voltage
⢠Supply-side current monitoring (10-bit ADC)
⢠10-bit ADC readout of supply voltage over I2C bus
⢠Two programmable general purpose sensor inputs
(COMP1/2) â UV/OV with FAULT Output
⢠Programmable glitch filters (COMP1/2)
⢠Programmable internal COMP1/2 VREF: 0.5V or 1.25V
⢠Operates from 2.7V to 5.5V supply
⢠Current sensing from 4.0V to 15V supply
⢠Programmable general-purpose inputs/outputs
⢠General-purpose 256-Byte EEPROM with Write Protect
⢠I2C 2-wire serial bus for programming configuration and
monitoring status
⢠28-lead 5x5 QFN package
Applications
⢠In-system test and control of Point-of-Load (POL)
⢠Power Supplies for Multi-voltage Processors, DSPs
and ASICs
⢠Routers, Servers, Storage Area Networks
The SMM153 is a highly accurate power supply
voltage/current supervisor and monitor that allows real-
time power measurement for power-critical designs. The
part includes an internal voltage reference to accurately
monitor the supply to within ±1%. The SMM153 can read
the differential voltage of the supply and voltage drop of
the current sense resistor over the I2C bus using an on-
chip 10-bit ADC.
Two general purpose analog input pins are provided for
sensing under- or over-voltage conditions. A
programmable glitch filter associated with these inputs
allows the user to ignore spurious noise signals. A
FAULT# pin is asserted once either input set point is
exceeded. The SMM153 also provides four
programmable general-purpose inputs/outputs.
Using the I2C interface, a host system can communicate
with the SMM153 status register and utilize 256-bytes of
nonvolatile memory. The SMM153 operates from +2.7V
to +5.5V, however it can sense input current from an
input supply of +4.0V to +15V. The device is offered in
both commercial and industrial temperature ranges and
the package is a space-saving 5x5 QFN-28 one.
TYPICAL APPLICATION
12VIN
RS
2.7V-5.5V
Status
Output
I2C
Interface
CAPC
CS-
CS+
FAULT#
SDA
SCL
A0-A2
WP
GPIO0
GPIO1
GPIO2
GPIO3
VDD
GND VDD_CAP
COMP1
V1
SMM153
COMP2
VREF
CAPM+
CAPM-
VM+
VM-
VIN VOUT+
SEN+
VOUT-
SEN-
DC-DC Converter
Figure 1 â Application with the SMM153 used to Monitor a DC/DC Converter.
Notes: RS must be Kelvin sensed for maximum current sensing accuracy. This is an applications example only. Some components and values
are not shown.
© SUMMIT Microelectronics, Inc. 2007 ⢠757 N. Mary Avenue ⢠Sunnyvale CA 94085 ⢠Phone 408 523-1000 ⢠FAX 408 523-1266
http://www.summitmicro.com/
2134 3.0 1/20/2010
1
|
▷ |