STM8S207MB_10 Datasheet, PDF (98/103 Pages) STMicroelectronics – Performance line, 24 MHz STM8S 8-bit MCU, up to 128 Kbytes Flash, integrated EEPROM,10-bit ADC, timers, 2 UARTs, SPI, I²C, CAN

STM8 development tools
12 STM8 development tools
STM8S207xx, STM8S208xx
Development tools for the STM8 microcontrollers include the full-featured STice emulation
system supported by a complete software tool package including C compiler, assembler and
integrated development environment with high-level language debugger. In addition, the
STM8 is to be supported by a complete range of tools including starter kits, evaluation
boards and a low-cost in-circuit debugger/programmer.
12.1
Emulation and in-circuit debugging tools
The STice emulation system offers a complete range of emulation and in-circuit debugging
features on a platform that is designed for versatility and cost-effectiveness. In addition,
STM8 application development is supported by a low-cost in-circuit debugger/programmer.
The STice is the fourth generation of full featured emulators from STMicroelectronics. It
offers new advanced debugging capabilities including profiling and coverage to help detect
and eliminate bottlenecks in application execution and dead code when fine tuning an
application.
In addition, STice offers in-circuit debugging and programming of STM8 microcontrollers via
the STM8 single wire interface module (SWIM), which allows non-intrusive debugging of an
application while it runs on the target microcontroller.
For improved cost effectiveness, STice is based on a modular design that allows you to
order exactly what you need to meet your development requirements and to adapt your
emulation system to support existing and future ST microcontrollers.
STice key features
● Occurrence and time profiling and code coverage (new features)
● Advanced breakpoints with up to 4 levels of conditions
● Data breakpoints
● Program and data trace recording up to 128 KB records
● Read/write on the fly of memory during emulation
● In-circuit debugging/programming via SWIM protocol
● 8-bit probe analyzer
● 1 input and 2 output triggers
● Power supply follower managing application voltages between 1.62 to 5.5 V
● Modularity that allows you to specify the components you need to meet your
development requirements and adapt to future requirements
● Supported by free software tools that include integrated development environment
(IDE), programming software interface and assembler for STM8.
98/103
Doc ID 14733 Rev 9