ESDCAN02-2BWY Datasheet, PDF (8/10 Pages) STMicroelectronics – transient voltage suppressor for CAN bus

Package information
ESDCAN0x-2BWY
2.2
PCB design preference
1. To control the solder paste amount, the closed via is recommended instead of open
vias.
2. The position of tracks and open vias in the solder area should be well balanced. The
symmetrical layout is recommended, in case any tilt phenomena caused by
asymmetrical solder paste amount due to the solder flow away.
2.3
Reflow profile
Figure 16. ST ECOPACK® recommended soldering reflow profile for PCB mounting
7H PSHUDWXUHƒ&




ƒ&V





ƒ&V
ƒ&
VHF
PD[
ƒ&V
ƒ&V
ƒ&V
7LPHV
      
Minimize air convection currents in the reflow oven to avoid component movement.
Maximum soldering profile corresponds to the latest IPC/JEDEC J-STD-020.
8/10
DocID027651 Rev 2