|
STM32F398VE Datasheet, PDF (60/151 Pages) STMicroelectronics – CRC calculation unit | |||
|
◁ |
Electrical characteristics
STM32F398VE
Table 16. Current characteristics
Symbol
Ratings
Max.
Unit
ïIVDD
Total current into sum of all VDD_x power lines (source)
160
ïIVSS
IVDD
IVSS
Total current out of sum of all VSS_x ground lines (sink)
Maximum current into each VDD_x power line (source)(1)
Maximum current out of each VSS _x ground line (sink)(1)
-160
100
100
IIO(PIN)
ïIIO(PIN)
Output current sunk by any I/O and control pin
Output current source by any I/O and control pin
Total output current sunk by sum of all IOs and control pins(2)
Total output current sourced by sum of all IOs and control pins(2)
25
-25
mA
80
-80
Injected current on FT, FTf, and B pins(3)
-5/+0
IINJ(PIN)
Injected current on TC and RST pin(4)
±5
Injected current on TTa pins(5)
±5
ïIINJ(PIN)
Total injected current (sum of all I/O and control pins)(6)
±25
1. pAellrmmaititnedporawnegre(.VDD, VDDA) and ground (VSS and VSSA) pins must always be connected to the external power supply, in the
2. This current consumption must be correctly distributed over all I/Os and control pins.The total output current must not be
sunk/sourced between two consecutive power supply pins referring to high pin count LQFP packages.
3. Positive injection is not possible on these I/Os and does not occur for input voltages lower than the specified maximum
value.
4.
A positive injection
exceeded. Refer to
iTsainbdleu1ce5d: VboyltVagINe>chVaDrDacwtehriilsetiacsnefogratthiveeminajexicmtiounmisalilnodwuecdedinpbuytVvIoNl<taVgeSSv.aIlIuNeJ(sP.IN)
must
never
be
5. edAxispctouesrebidtsievtdeh.einRjaeenfceatirlooanglsipsoeitnrofdoTuramcbealdencb1ey5:oVVfINothl>teaVgdeDevDciAhcaewr.ahScileeteearinsnotietcegsa(f2toi)vrbetehilenojwemcaTtixaoibnmleiusm7in5a.dlulocweeddbiynpVuINt <voVltSaSg.eIIvNaJl(uPeINs.)Nmeugsattinveevienrjebcetion
6.
When several inputs are submitted to a current injection,
negative injected currents (instantaneous values).
the
maximum
ïIINJ(PIN)
is
the
absolute
sum
of
the
positive
and
Table 17. Thermal characteristics
Symbol
Ratings
Value
Unit
TSTG
TJ
Storage temperature range
Maximum junction temperature
-65 to +150
°C
150
°C
60/151
DocID027227 Rev 2
|
▷ |