AN2143 Datasheet, PDF (6/8 Pages) STMicroelectronics – Programming the ST10F27X embedded Flash

ST10Flasher settings
AN2143
1.5 Running the program
After successful programming, in order to run the program, some hardware considerations
should be taken into account:
● the bootstrap loader should be switched OFF
● the Single Chip mode ON by applying a high level to /EA pin.
● then, reset the controller.
If you use the application.HEX example delivered with this application note, you can use
hyperterminal to verfiy the application is working well.
For this purpose, start a terminal program on your PC with the line parameters 9600Baud, no
parity, 8 bit data and 1 stop bit.
If every thing is working properly, a small text will appear on your PC screen as shown in the
following Figure:
6/8