STM8S103F3P3 Datasheet, PDF (59/113 Pages) STMicroelectronics – Access line, 16 MHz STM8S 8-bit MCU, up to 8 Kbytes Flash, data EEPROM,10-bit ADC, 3 timers, UART, SPI, I2C

STM8S103K3 STM8S103F3 STM8S103F2
Electrical characteristics
Symbol Parameter
Conditions
Typ _Max⁽¹⁾ Unit
Wakeup time active
halt mode to run
mode⁽³⁾
MVR voltage
regulator
off⁽⁴⁾
Flash in operating
mode⁽⁵⁾
HSI
(after
wakeup)
48⁽⁶⁾
Wakeup time active
halt mode to run
mode⁽³⁾
MVR voltage Flash in
regulator
off⁽⁴⁾
power-down
mode⁽⁵⁾
t_WU(H)
Wakeup time from
halt mode to run
mode⁽³⁾
Flash in operating mode⁽⁵⁾
Flash in power-down mode⁽⁵⁾
HSI
(after
50⁽⁶⁾
wakeup)
52
54
(1) _{Data guaranteed by design, not tested in production.}
(2) _{tWU(WFI) = 2 x 1/fmaster + 6 x 1/fCPU.}
(3) _{Measured from interrupt event to interrupt vector fetch.}
(4) _{Configured by the REGAH bit in the CLK_ICKR register.}
(5) _{Configured by the AHALT bit in the FLASH_CR1 register.}
(6) _{Plus 1 LSI clock depending on synchronization.}
10.3.2.6 Total current consumption and timing in forced reset state
Symbol
Table 30: Total current consumption and timing in forced reset state
Parameter
Conditions
Typ
Max^{(1) Unit}
I_DD(R)
t_RESETBL
Supply current in reset
state⁽²⁾
Reset pin release to
vector fetch
V_DD = 5 V
V_DD = 3.3 V
400
μA
300
150
μs
(1) _{Data guaranteed by design, not tested in production.}
(2) _{Characterized with all I/Os tied to VSS.}
10.3.2.7 Current consumption of on-chip peripherals
Subject to general operating conditions for V_DD and T_A.
DocID15441 Rev 6
59/113