STM32L071X8 Datasheet, PDF (56/136 Pages) STMicroelectronics – Access line ultra-low-power 32-bit MCU ARM-based Cortex-M0+, up to 192KB Flash, 20KB SRAM, 6KB EEPROM, ADC

Electrical characteristics
STM32L071xx
Table 23. Current characteristics
Symbol
Ratings
Max.
Unit
ΣI_VDD(2)
Total current into sum of all V_DD power lines (source)⁽¹⁾
105
ΣI_VSS(2)
Total current out of sum of all V_SS ground lines (sink)⁽¹⁾
105
ΣI_VDDIO2
Total current into V_DDIO2 power line (source)
25
I_VDD(PIN)
Maximum current into each V_DD power pin (source)⁽¹⁾
100
I_VSS(PIN)
Maximum current out of each V_SS ground pin (sink)⁽¹⁾
100
Output current sunk by any I/O and control pin except FTf
pins
16
I_IO
Output current sunk by FTf pins
22
Output current sourced by any I/O and control pin
-16
mA
Total output current sunk by sum of all IOs and control pins
except PA11 and PA12⁽²⁾
90
ΣI_IO(PIN)
Total output current sunk by PA11 and PA12
25
Total output current sourced by sum of all IOs and control
pins⁽²⁾
-90
I_INJ(PIN)
Injected current on FT, FFf, RST and B pins
Injected current on TC pin
-5/+0⁽³⁾
± 5⁽⁴⁾
ΣI_INJ(PIN)
Total injected current (sum of all I/O and control pins)⁽⁵⁾
± 25
1. _{sAullpmplayi,ninpothweepr e(VrmDiDtt,eVdDrDaAn)gaen.} d ground (V_SS, V_SSA) pins must always be connected to the external power
2. This current consumption must be correctly distributed over all I/Os and control pins. The total output
current must not be sunk/sourced between two consecutive power supply pins referring to high pin count
LQFP packages.
3.
Positive current injection is not possible on these I/Os. A negative
must never be exceeded. Refer to Table 22 for maximum allowed
injection is induced by
input voltage values.
V_IN<V_SS.
I_INJ(PIN)
4. Amupsotsniteivveerinbjeecetixocneiesdiendd.uRceedfebrytoV_TINab>_leV_2D2D:w_Vh_oi_ll_te_aga_en_ce_hg_aa_rt_aiv_ce_tei_rn_isje_tic_ct_siofnoristhinedmucaexdimbuymVa_{INllo<wVeSdSi.nIpINuJt(PvoINlt)age}
values.
5.
When several inputs are submitted to a
positive and negative injected currents
current injection, the maximum
(instantaneous values).
I_INJ(PIN)
is
the
absolute
sum
of
the
Table 24. Thermal characteristics
Symbol
Ratings
Value
Unit
T_STG
T_J
Storage temperature range
Maximum junction temperature
–65 to +150
°C
150
°C
56/136
DocID027101 Rev 3