STM8S003K3 Datasheet, PDF (46/100 Pages) STMicroelectronics – Value line, 16 MHz STM8S 8-bit MCU, 8 Kbytes Flash, 128 bytes

Electrical characteristics
STM8S003K3 STM8S003F3
9
9.1
9.1.1
9.1.2
9.1.3
9.1.4
Electrical characteristics
Parameter conditions
Unless otherwise specified, all voltages are referred to V_SS.
Minimum and maximum values
Unless otherwise specified the minimum and maximum values are guaranteed in the worst
conditions of ambient temperature, supply voltage and frequencies by tests in production on
100 % of the devices with an ambient temperature at T_A = 25 °C and T_A = T_Amax (given by
the selected temperature range).
Data based on characterization results, design simulation and/or technology characteristics
are indicated in the table footnotes and are not tested in production. Based on characterization,
the minimum and maximum values refer to sample tests and represent the mean value plus
or minus three times the standard deviation (mean ± 3 Σ).
Typical values
Unless otherwise specified, typical data are based on T_A = 25 °C, V_DD = 5 V. They are given
only as design guidelines and are not tested.
Typical ADC accuracy values are determined by characterization of a batch of samples from
a standard diffusion lot over the full temperature range, where 95% of the devices have an
error less than or equal to the value indicated (mean ± 2 Σ).
Typical curves
Unless otherwise specified, all typical curves are given only as design guidelines and are not
tested.
Loading capacitor
The loading conditions used for pin parameter measurement are shown in the following figure.
Figure 7: Pin loading conditions
50 pF
STM8 pin
9.1.5
Pin input voltage
The input voltage measurement on a pin of the device is described in the following figure.
46/100
DocID018576 Rev 3