|
AN4291 Datasheet, PDF (45/53 Pages) STMicroelectronics – STEVAL385LED4CH: four independent high brightness LED | |||
|
◁ |
AN4291
Pinout
Table 6. STLUX385A pinout (continued)
Pin
Dir.
Function
Note
29
PS
VDDA
Analog power supply
30
PS
VSSA
Analog ground
31
A-IN
ADCIN[7]
Key input â voltage depends whether key is pressed or
not
32
A-IN
ADCIN[6]
External dimming signal â 0 -10 V equal to 0% 100% â
(option)
33
A-IN
ADCIN[5]
Not used
34
A-IN
ADCIN[4]
Analog input CH4 â VCOM3 â voltage from LED3 chain
35
A-IN
ADCIN[3]
Analog input CH3 â VCOM2 â voltage from LED2 chain
36
A-IN
ADCIN[2]
Analog input CH2 â VCOM1 â voltage from LED1 chain
37
A-IN
ADCIN[1]
Analog input CH1 â VCOM0 â voltage from LED0 chain
38
A-IN
ADCIN[0]
Analog input CH0 â ADCIN0 â voltage on VLED_PW
signal (VIN)
Note:
When the DALI I/F is used, please remove R78, R77 resistor (lose RUN-FAULT function),
enable the "USE_DALI" constant on the "led.h" source file, recompile and load the new
code.To request the source code for the DALI stack, please contact your local ST
representative. The STEVAL-ILM001V1 kit gives access to the DALI hardware interface.
DocID024519 Rev 1
45/53
|
▷ |