TDA8214B Datasheet, PDF (4/9 Pages) STMicroelectronics – HORIZONTAL AND VERTICAL DEFLECTION CIRCUIT

TDA8214B
ELECTRICAL CHARACTERISTICS (continued)
VCC1 = 10V, TAMB = 25^oC (unless otherwise specified )
Symbol
Parameter
Min. Typ. Max. Unit
FRAME POWER SUPPLY (Pin 9)
V9
Operating Voltage (with flyback Generator)
I9
Supply Current (V9 = 30V)
10
58 V
11
22 mA
FLYBACK GENERATOR SUPPLY (Pin 3)
VCC2 Operating Voltage
FRAME OUTPUT (Pin 10)
10
30 V
LV10A
LV10B
HV10A
HV10B
FV10A
FV10B
Saturation Voltage to Ground (V9 = 30V)
I10 = 0.1A
I10 = 1A
Saturation Voltage to V9 (V9 = 30V)
I10 = -0.1A
I10 = -1A
Saturation Voltage to V9 in Flyback Mode (V10 > V9)
I10 = 0.1A
I10 = 1A
0.06 0.6 V
0.37 1
V
1.3 1.6 V
1.7 2.4 V
1.6 2.1 V
2.5 4.5 V
FLYBACK GENERATOR (Pin 3 and Pin 4)
F2DA
F2DB
FSVA
FSVB
FCI
Flyback Transistor on (output = high state), VCC2 = 30V V4/3 with
I4 → 3 = 0.1A
I4 → 3 = 1A
Flyback Transistor on (output = high state), VCC2 = 30V V3/4 with
I3 → 4 = 0.1A
I3 → 4 = 1A
Flyback Transistor off (output = V9 - 8V), V9 - VCC2 = 30V
Leakage Current Pin 3
1.5 2.1 V
3.0 4.5 V
0.8 1.1 V
2.2 4.5 V
170 µA
SUPER SANDCASTLE OUTPUT (Pin 19)
SANDT2
SANDL2
BG2
SC3
SC2
Output Voltages (R load = 2.2kΩ)
Frame blanking pulse level
Line blanking pulse level
Burst key pulse level
Pulses width and timing
Delay between middle of sync pulse and leading edge of burst key pulse
Duration of burst key pulse
Vertical blanking pulse width
2
2.5
3
V
4
4.5
5
V
8
9
V
2.3 2.7 3.1 µs
3.7
4
5 µs
Note 1
LINE FLYBACK INPUT (Pin 18)
Switching level
Maximum imput current at VPEAK = 800V
Limiting voltage at maximum current
τ
RC network time constant (Note 2)
2
V
8
mA
4.3
V
6
µs
Notes :
1. Width of vertical blanking pulse on SSC output is proportional to the frame flyback time, the switching level is VCC2 - 2VBE and
the other input of the comparator is tied to the frame amplifier output. Application circuit uses the frame flyback generator.
2. An RC network is connected to this input. Typical value for the resistor is 27kΩ and 220pF for the capacitor. A different time
constant for RC changes the delay between the middle of the line synchro pulse and the leading edge of the burst key pulse but
also the duration of the burst key pulse.
4/9