EVAL6206Q Datasheet, PDF (4/12 Pages) STMicroelectronics – Adjustable overcurrent threshold

Board description
EVAL6206Q
Pin
2
3
4
5
6
11
12
13
14
16
23
24
25
27
28
29
30
Others
Table 2. Control board connector pinout (J2)
Type
Function
Ground
Ground
Logic input
Logic input
Logic input
Logic input
Input IN1A of L6206Q
Input IN2A of L6206Q
Input IN1B of L6206Q
Input IN2B of L6206Q
Analog input
Overcurrent threshold regulation for A bridge
Analog input
Ground
Supply voltage
Logic input
Overcurrent threshold regulation for B bridge
Ground
3.3 V supply voltage
Input ENA of L6206Q
Ground
Analog output
Analog output
Logic output
Ground
Board identification system ID0
Board identification system ID1
Fault output for A bridge (OCDA output of L6206Q)
Ground
Ground
Logic output
Logic input
Unconnected
Fault output for B bridge (OCDB output of L6206Q)
Input ENB of L6206Q
Table 3. Current sensing connector (J9)
Pin
Type
Function
1
Ground
Ground
2
Analog output
SENSEA pin of L6206Q⁽¹⁾
3
Analog output
SENSEB pin of L6206Q⁽¹⁾
4
Ground
Ground
1. The R22/23 resistor and C12/13 capacitor must be added when output is used. The value of the RC
network should be chosen according to the target low-pass frequency of the filter.
4/12
DocID023042 Rev 2