AS11P2TLR Datasheet, PDF (4/18 Pages) STMicroelectronics – Low voltage 1 Ω single-pole double-throw analog switch with break before make feature

Electrical ratings
2
Electrical ratings
AS11P2TLR
Stressing the device above the rating listed in Table 4: Absolute maximum ratings may
cause permanent damage to the device. These are stress ratings only and operation of the
device at these or any other conditions above those indicated in Table 5: Recommended
operating conditions of this specification is not implied. Exposure to absolute maximum
rating conditions for extended periods may affect device reliability. Refer also to the
STMicroelectronics™ SURE program and other relevant quality documents.
Table 4. Absolute maximum ratings
Symbol
Parameter
Value
Unit
V_CC
Supply voltage
–0.5 to 5.5
V
V_I
DC input voltage
–0.5 to V_CC +0.5
V
V_IC
DC control input voltage
–0.5 to 5.5
V
V_O
DC output voltage
–0.5 to V_CC +0.5
V
I_IKC
DC input diode current on control pin (V_SEL < 0 V)
–50
mA
I_IK
DC input diode current (V_IN < 0 V)
±50
mA
I_OK
DC output diode current
±20
mA
I_O
DC output current
±200
mA
I_OP
DC output current peak
(pulse at 1 ms, 10% duty cycle)
±400
mA
I_CC or I_GND DC V_CC or ground current
P_D
Power dissipation at T_A = 70 °C⁽¹⁾
T_STG
Storage temperature
T_L
Lead temperature (10 s)
1. Derate above 70 °C by 18.5 mW/°C.
±100
mA
1120
mW
–65 to 150
°C
300
°C
Symbol
V_CC
V_I
V_IC
V_O
T_op
dt/dv
Table 5. Recommended operating conditions
Parameter
Value
Supply voltage
1.65 to 4.5
Input voltage
Control input voltage
0 to V_CC
0 to 4.5
Output voltage
Operating temperature
0 to V_CC
–40 to 85
Input rise and fall time
control input
V_CC = 1.65 to 2.7 V
V_CC = 3.0 to 4.5 V
0 to 20
0 to 10
Unit
V
V
V
V
°C
ns/V
4/18
DocID026034 Rev 1