UM0272 Datasheet, PDF (36/40 Pages) STMicroelectronics – Central Unit for Alarm System

Menus
UM0272
5.6.10
Central Unit
The Central Unit menu displays CU serial number. Press any key to return to the previous
menu.
5.7
CM Setup
The CM setup menu (Figure 35) is used to set the current CM address and to modify the
installation code.
Figure 35. Control module setup menu
Press 1 to display the current CM address. Press ENT to modify the address. This value
must be entered when installing the system, in order to assign a valid CM address before
storing the CU address (see Modules Acquisition on page 32) or when a new CM is added
on the bus.
Press 2 to display or modify the installation code. This must be performed when installing
the system and each time a new CM is installed on the BUS. Press ENT to modify the
installation code. This code must match the one programmed on the CU (00000000 by
default), otherwise the setup procedure is impossible (see Section 5.6.4: Installation code).
36/40