TDA7405_04 Datasheet, PDF (33/57 Pages) STMicroelectronics – EQUALIZER CARRADIO SIGNAL PROCESSOR

TDA7405
10.8 Stereoblend Control
The stereoblend control block converts the internal LEVEL-voltage (LEVELSB) into an demodulator compatible
analog signal which is used to control the channel separation between 0dB and the maximum separation. Inter-
nally this control range has a fixed upper limit which is the internal reference voltage REF5V. The lower limit can
be programmed between 20 and 70% of REF5V in 3.3% steps (see Figure 31, Figure 29).
To adjust the external LEVEL-voltage to the internal range two values must be defined: the LEVEL gain LG and
VSBL (see Figure 32). At the point of full channel separation the external level signal has to be amplified that
internally it becomes equal to REF5V. The second point (e.g. 10dB channel sep.) is then adjusted with the VSBL
voltage.
Figure 32. Internal stereoblend characteristics
The gain can be programmed through 4 bits in the "Stereodecoder-Adjustment"-byte. All necessary internal ref-
erence voltages like REF5V are derived from a bandgap circuit. Therefore they have a temperature coefficient
near zero.
Figure 33. Relation between internal and external LEVEL-voltages for setup of Stereoblend
70
20
10.9 Highcut Control
The highcut control setup is similar to the stereoblend control setup : the starting point VHCH can be set with 2
bits to be 42, 50, 58 or 66% of REF5V whereas the range can be set to be 17, 22, 28 or 33% of VHCH (see
Figure 30).
33/57