VV5404 Datasheet, PDF (32/54 Pages) List of Unclassifed Manufacturers – CIF FORMAT DIGITAL IMAGE SENSOR

VV5404 & VV6404
5.5.4 Setup0 [001_0000₂]
Bit
Function
Default
Comment
0 Low Power Mode:
Off/On
1 Sleep Mode:
Off/On
2 Soft Reset
Off/On
3 Frame Rate select:
25 fps or 30 fps
4 Tri-state output data bus
Outputs Enabled/Tristate
7:5 unused
1
Powers down the sensor array. The output
databus goes to F_H. On power-up the sensor
enters low power mode.
0
Puts the sensor array into reset. The output
databus goes to F_H.
0
Setting this bit resets the sensor to its power-up
defaults. This bit is also reset.
1
0
On power up the data output pads D[3:0] are
enabled by default.
Table 13 : Setup0 [001_0000₂]
5.5.5 Setup1 [001_0001₂]
Bit
Function
Default
Comment
1:0 Black calibration mode selection
2 reserved
3 Enable immediate clock division
update. Off/On
4 Enable immediate gain update.
Off/On
5 Enable additional black lines (lines
3-9) Off/On
6 Border rows and columns:
Masked or Output
7 Pixel read-out order:
Unshuffled or Shuffled
10
Black calibration trigger selection. Default
setting bases decision on result of monitor
test. See table below
0
Allow manual change to clock division to be
applied immediately
0
Allow manual change to gain to be applied
immediately
0
If enabled this bit will also enable the line
immediately following the end of frame line
1
These extra pixels/rows are used in colour
processing
1
It is strongly recommended to use shuffled
read-out.
Table 14 : Setup1 [001_0001₂]
CD5404-6404F-A
32/54