STRT71XF Datasheet, PDF (32/74 Pages) STMicroelectronics – ARM7TDMI™ 32-bit MCU with Flash, USB, CAN 5 timers, ADC, 10 communications interfaces

Electrical parameters
2
Electrical parameters
STR71xF
2.1
2.1.1
2.1.2
2.1.3
2.1.4
2.1.5
Parameter conditions
Unless otherwise specified, all voltages are referred to V_SS.
Minimum and maximum values
Unless otherwise specified the minimum and maximum values are guaranteed in the worst
conditions of ambient temperature, supply voltage and frequencies by tests in production on
100% of the devices with an ambient temperature at T_A=25°C and T_A=T_Amax (given by the
selected temperature range).
Data based on characterization results, design simulation and/or technology characteristics
are indicated in the table footnotes and are not tested in production. Based on
characterization, the minimum and maximum values refer to sample tests and represent the
mean value plus or minus three times the standard deviation (mean±3Σ).
Typical values
Unless otherwise specified, typical data are based on T_A=25°C, V₃₃=3.3V (for the
3.0V≤V₃₃≤3.6V voltage range) and V₁₈=1.8V. They are given only as design guidelines and
are not tested.
Typical ADC accuracy values are determined by characterization of a batch of samples from
a standard diffusion lot over the full temperature range, where 95% of the devices have an
error less than or equal to the value indicated (mean±2Σ).
Typical curves
Unless otherwise specified, all typical curves are given only as design guidelines and are
not tested.
Loading capacitor
The loading conditions used for pin parameter measurement are shown in Figure 9.
Pin input voltage
The input voltage measurement on a pin of the device is described in Figure 10.
Figure 9. Pin loading conditions
Figure 10. Pin input voltage
L^=50pF
STR7 PIN
STR7 PIN
V_IN
32/74