STM32F101T6U6A Datasheet, PDF (29/79 Pages) STMicroelectronics – Low-density access line, ARM-based 32-bit MCU with 16 or 32 KB Flash, 5 timers, ADC and 4 communication interfaces

STM32F101x4, STM32F101x6
Electrical characteristics
5.1.7
Current consumption measurement
Figure 11. Current consumption measurement scheme
IDD_VBAT
VBAT
IDD
VDD
VDDA
ai14126
5.2
Absolute maximum ratings
Stresses above the absolute maximum ratings listed in Table 5: Voltage characteristics,
Table 6: Current characteristics, and Table 7: Thermal characteristics may cause permanent
damage to the device. These are stress ratings only and functional operation of the device
at these conditions is not implied. Exposure to maximum rating conditions for extended
periods may affect device reliability.
Table 5. Voltage characteristics
Symbol
Ratings
Min
Max
Unit
V_DD − V_SS
V_IN(2)
External main supply voltage (including
V_DDA and V_DD)⁽¹⁾
Input voltage on five volt tolerant pin
Input voltage on any other pin
–0.3
4.0
V_SS − 0.3
V_DD + 4.0
V
V_SS − 0.3
4.0
|ΔV_DDx| Variations between different V_DD power pins
|V_SSX − V_SS|
Variations between all the different ground
pins
50
mV
50
V_ESD(HBM)
Electrostatic discharge voltage (human body
model)
see Section 5.3.11: Absolute
maximum ratings (electrical
sensitivity)
1. All main power (V_DD, V_DDA) and ground (V_SS, V_SSA) pins must always be connected to the external power
supply, in the permitted range.
2. V_IN maximum must always be respected. Refer to Table 6: Current characteristics for the maximum
allowed injected current values.
Doc ID 15058 Rev 5
29/79