MIS2DH Datasheet, PDF (28/49 Pages) STMicroelectronics – ultra-low-power high-performance 3-axis accelerometer

Digital interfaces
5.2.2 SPI write
Figure 9. SPI write protocol
MIS2DH
CS
SPC
SDI
RW
D I7 D I6 D I5 D I4 DI3 DI2 DI1 DI0
MS AD5 AD 4 AD 3 AD2 AD 1 AD0
AM10132V1
The SPI write command is performed with 16 clock pulses. A multiple byte write command
is performed by adding blocks of 8 clock pulses to the previous one.
bit 0: WRITE bit. The value is 0.
bit 1: MS bit. When 0, does not increment the address, when 1, increments the address in
multiple writes.
bit 2 -7: address AD(5:0). This is the address field of the indexed register.
bit 8-15: data DI(7:0) (write mode). This is the data that is written inside the device (MSb
first).
bit 16-... : data DI(...-8). Further data in multiple byte writes.
Figure 10. Multiple byte SPI write protocol (2-byte example)
CS
SPC
SDI
RW
DI7 D I6 DI5 D I4 DI3 DI2 DI1 DI0 DI15 D I1 4 DI13 D I1 2 DI11 DI10 DI9 DI8
MS _{AD5 AD4 AD3 AD2 AD1 AD 0}
AM10133V1
28/49
DocID027506 Rev 2