M48T212Y Datasheet, PDF (23/32 Pages) STMicroelectronics – 5V/3.3V TIMEKEEPER CONTROLLER Supervisor

M48T212Y, M48T212V
MAXIMUM RATING
Stressing the device above the rating listed in the
“Absolute Maximum Ratings” table may cause
permanent damage to the device. These are
stress ratings only and operation of the device at
these or any other conditions above those indicat-
ed in the Operating sections of this specification is
not implied. Exposure to Absolute Maximum Rat-
ing conditions for extended periods may affect de-
vice reliability. Refer also to the
STMicroelectronics SURE Program and other rel-
evant quality documents.
Table 11. Absolute Maximum Ratings
Symbol
Parameter
Value
Unit
T_A
Ambient Operating Temperature
0 to 70
°C
T_STG
Storage Temperature
SNAPHAT^®
SOIC
–40 to 85
°C
–55 to 125
°C
T_SLD(1,2)
Lead Solder Temperature for 10 seconds
260
°C
V_IO
Input or Output Voltage
–0.3 to V_CC + 0.3
V
V_CC
Supply Voltage
M48T212Y
M48T212V
–0.3 to 7.0
V
–0.3 to 4.6
V
I_O
Output Current
20
mA
P_D
Power Dissipation
1
W
Note: 1. For SO package, standard (SnPb) lead finish: Reflow at peak temperature of 225°C (total thermal budget not to exceed 180°C for
between 90 to 150 seconds).
2. For SO package, Lead-free (Pb-free) lead finish: Reflow at peak temperature of 260°C (total thermal budget not to exceed 245°C
for greater than 30 seconds).
CAUTION: Negative undershoots below –0.3V are not allowed on any pin while in the Battery Back-up mode.
CAUTION: Do NOT wave solder SOIC to avoid damaging SNAPHAT sockets.
23/32