TDA7498L Datasheet, PDF (22/27 Pages) STMicroelectronics – 80 watt + 80 watt dual BTL class-D audio amplifier

Applications information
TDA7498L
5.6
Output low-pass filter
To avoid EMI problems, it may be necessary to use a low-pass filter before the speaker. The
cutoff frequency should be larger than 22 kHz and much lower than the output switching
frequency. It is necessary to choose the L and C component values depending on the
loudspeaker impedance. Some typical values, which give a cutoff frequency of 27 kHz, are
shown in Figure 25 and Figure 26 below.
Figure 25. Typical LC filter for a 8-Ω speaker
07-?0
07-?.
U(
P&
N&
OHM
U(
OHM
N&
N&
OHM
N&
N&
OHM
Figure 26. Typical LC filter for a 6-Ω speaker
07-?0
07-?.
U(
P&
N&
OHM
U(
OHM
N&
N&
OHM
N&
N&
OHM
22/27
Doc ID 16504 Rev 3