TDA7491HV Datasheet, PDF (22/26 Pages) STMicroelectronics – 20 W + 20 W dual BTL class-D audio amplifier

Application information
TDA7491HV
7.6
Output low-pass filter
To avoid EMI problems, it may be necessary to use a low-pass filter before the speaker. The
cutoff frequency should be larger than 22 kHz and much lower than the output switching
frequency. It is necessary to choose the L-C component values depending on the loud
speaker impedance. Some typical values, which give a cut-off frequency of 27 kHz, are
shown in Figure 28 and Figure 29 below.
Figure 28. Typical LC filter for a 8-Ω speaker
Figure 29. Typical LC filter for a 4-Ω speaker
22/26