TDA7491MV Datasheet, PDF (21/28 Pages) STMicroelectronics – 25 W mono BTL class-D audio amplifier

TDA7491MV
Application information
7.2
Gain setting
The gain of the TDA7491MV is set by the two inputs, GAIN0 (pin 30) and GAIN1 (pin 31).
Internally, the gain is set by changing the feedback resistors of the amplifier.
Table 8. Gain settings
GAIN0
0
0
0
1
1
0
1
1
GAIN1
Nominal gain, G_v (dB)
20
26
30
32
7.3
Input resistance and capacitance
The input impedance is set by an internal resistor Ri = 60 kΩ (typical). An input capacitor
(Ci) is required to couple the AC input signal.
The equivalent circuit and frequency response of the input components are shown in
Figure 21. For Ci = 220 nF the high-pass filter cut-off frequency is below 20 Hz:
fc = 1 / (2 * π * Ri * Ci)
Figure 21. Device input circuit and frequency response
Rf
Input
signal
Ci
Input _Ri
pin
Doc ID 14576 Rev 2
21/28