TDA7498MV Datasheet, PDF (20/27 Pages) STMicroelectronics – 100-watt mono BTL class-D audio amplifier

Applications information
TDA7498MV
5.3
Gain setting
The gain of the TDA7498MV is set by the two inputs, GAIN0 (pin 30) and GAIN1 (pin31).
Internally, the gain is set by changing the feedback resistors of the amplifier.
Table 8. Gain settings
GAIN0
L
L
L
H
H
L
H
H
GAIN1
Nominal gain, G_v (dB)
25.6
31.6
35.6
37.6
5.4
Input resistance and capacitance
The input impedance is set by an internal resistor Ri = 60 kΩ (typical). An input capacitor
(Ci) is required to couple the AC input signal.
The equivalent circuit and frequency response of the input components are shown in
Figure 21. For Ci = 470 nF the high-pass filter cut-off frequency is below 20 Hz:
f_C = 1 / (2 * π * Ri * Ci)
Figure 21. Input circuit and frequency response
Rf
Input
signal
Ci
Input _Ri
pin
20/27
Doc ID 16505 Rev 3