M95020-A125 Datasheet, PDF (18/41 Pages) STMicroelectronics – Automotive 2-Kbit serial SPI bus EEPROMs

Instructions
M95020-A125 M95020-A145
4.5
Read from Memory Array (READ)
The READ instruction is used to read the content of the memory.
As shown in Figure 9, to send this instruction to the device, Chip Select (S) is first driven
low.
The bits of the instruction byte and address byte are then shifted in, on Serial Data Input
(D).The address is loaded into an internal address register, and the byte of data at that
address is shifted out, on Serial Data Output (Q).
If Chip Select (S) continues to be driven low, the internal address register is automatically
incremented, and the next byte of data is shifted out. The whole memory can therefore be
read with a single READ instruction.
When the highest address is reached, the address counter rolls over to zero, allowing the
Read cycle to be continued indefinitely.
The Read cycle is terminated by driving Chip Select (S) high at any time when the data bits
are shifted out on Serial Data Output (Q).
The instruction is not accepted, and is not executed, if a Write cycle is currently in progress.
Figure 9. Read from Memory Array (READ) sequence
3
                      
#
)NSTRUCTION
"YTE!DDRESS
$
! ! ! ! ! ! ! !
(IGH)MPEDANCE
1
$ATA/UT

!)&
18/41
DocID025284 Rev 5