TDA7416 Datasheet, PDF (17/27 Pages) STMicroelectronics – CARRADIO SIGNAL PROCESSOR

TDA7416
2 I²C BUS INTERFACE
2.1 Interface Protocol
The interface protocol comprises:
-a start condition (S)
-a chip address byte (the LSB bit determines read / write transmission)
-a subaddress byte
-a sequence of data (N-bytes + acknowledge)
-a stop condition (P)
CHIP ADDRESS
SUBADDRESS
DATA 1...DATA n
MSB
LSB
MSB
LSB
MSB
S 1 0 0 0 1 1 0 R/W ACK T AZ I A A A A A ACK
S = Start
R/W = “0” -> Receive-Mode (Chip could be programmed by µP)
“1” -> Transmission-Mode (Data could be received by µP)
ACK = Acknowledge
P = Stop
MAX CLOCK SPEED 500kbits/s
DATA
LSB
ACK P
2.1.1 Auto increment
If bit I in the subaddress byte is set to “1”, the auto increment of the subaddress is enabled.
2.1.2 TRANSMITTED DATA (send mode)
MSB
LSB
X X X X X X X SM
SM = Soft mute activated
X = Not Used
The transmitted data is automatically updated after each ACK.
Transmission can be repeated without new chip address.
2.1.3 Reset Condition
A Power-On-Reset is invoked if the Supply-Voltage is below than 3.5V. After that, the following data is written
automatically into the registers of all subaddresses:
MSB
LSB
1
1
1
1
1
1
1
0
The programming after POR is marked bold-face / underlined in the programming tables.
With this programming all the outputs are muted to V_REF (V_OUT= V_DD/2).
17/27