M29W800DT70N1 Datasheet, PDF (16/41 Pages) STMicroelectronics – 8 Mbit (1Mb x8 or 512Kb x16, Boot Block) 3V Supply Flash Memory

M29W800DT, M29W800DB
Table 5. Commands, 8-bit mode, BYTE = V_IL
Bus Write Operations
Command
1st
2nd
3rd
4th
5th
6th
Addr Data Addr Data Addr Data Addr Data Addr Data Addr Data
Read/Reset
1 X F0
3 AAA AA 555 55 X F0
Auto Select
3 AAA AA 555 55 AAA 90
Program
4 AAA AA 555 55 AAA A0 PA PD
Unlock Bypass
3 AAA AA 555 55 AAA 20
Unlock Bypass
Program
2 X A0 PA PD
Unlock Bypass Reset 2 X 90 X 00
Chip Erase
6 AAA AA 555 55 AAA 80 AAA AA 555 55 AAA 10
Block Erase
6+ AAA AA 555 55 AAA 80 AAA AA 555 55 BA 30
Erase Suspend
1 X B0
Erase Resume
1 X 30
Read CFI Query
1 AA 98
Note: X Don’t Care, PA Program Address, PD Program Data, BA Any address in the Block.
All values in the table are in hexadecimal.
The Command Interface only uses A–1, A0-A10 and DQ0-DQ7 to verify the commands; A11-A18, DQ8-DQ14 and DQ15 are Don’t
Care. DQ15A–1 is A–1 when BYTE is V_IL or DQ15 when BYTE is V_IH.
Table 6. Program, Erase Times and Program, Erase Endurance Cycles
Parameter
Min
Typ ^{(1, 2)}
Max⁽²⁾
Unit
Chip Erase
12
60⁽³⁾
s
Block Erase (64 Kbytes)
0.8
6⁽⁴⁾
s
Erase Suspend Latency Time
15
25⁽³⁾
µs
Program (Byte or Word)
10
200⁽³⁾
µs
Chip Program (Byte by Byte)
12
60⁽³⁾
s
Chip Program (Word by Word)
6
30⁽⁴⁾
s
Program/Erase Cycles (per Block)
100,000
cycles
Data Retention
20
years
Note: 1. Typical values measured at room temperature and nominal voltages.
2. Sampled, but not 100% tested.
3. Maximum value measured at worst case conditions for both temperature and V_CC after 100,00 program/erase cycles.
4. Maximum value measured at worst case conditions for both temperature and V_CC.
16/41