AN4396 Datasheet, PDF (15/19 Pages) STMicroelectronics – The STEVAL-ISV021V1 is a demonstration kit which consists

AN4396
Harvesting module and power monitoring board
Before to connect the harvester module to the power monitoring board, set the jumpers as
described below:
 Close pins 2 - 3 of the J4 in order to supply the SPV1050 device by the on-board PV
panel
 Close pins 2 - 3 of the J5 in order to allow the power monitoring to sense the input
voltage and current.
 Close pins 2 - 3 of the J6 in order to allow the power monitoring to sense the battery
voltage and current.
 Close pins 2 - 3 of the J7 in order to allow the power monitoring to sense the ambient
light on the PV panel.
Figure 6. Jumper configuration for harvester module connected to power monitoring
board
DocID025514 Rev 1
15/19
19