M93C46-WMN6P Datasheet, PDF (11/33 Pages) STMicroelectronics – 16-Kbit, 8-Kbit, 4-Kbit, 2-Kbit and 1-Kbit (8-bit or 16-bit wide) MICROWIRE serial access EEPROM

M93C86xx M93C76xx M93C66xx M93C56xx M93C46xx
5
Instructions
Instructions
The instruction set of the M93Cx6 devices contains seven instructions, as summarized in
Table 4 to Table 6. Each instruction consists of the following parts, as shown in Figure 4:
READ, WRITE, WEN, WDS sequences:
• Each instruction is preceded by a rising edge on Chip Select Input (S) with Serial Clock
(C) being held low.
• A start bit, which is the first ‘1’ read on Serial Data Input (D) during the rising edge of
Serial Clock (C).
• Two op-code bits, read on Serial Data Input (D) during the rising edge of Serial Clock
(C). (Some instructions also use the first two bits of the address to define the op-code).
• The address bits of the byte or word that is to be accessed. For the M93C46, the
address is made up of 6 bits for the x16 organization or 7 bits for the x8 organization
(see Table 4). For the M93C56 and M93C66, the address is made up of 8 bits for the
x16 organization or 9 bits for the x8 organization (see Table 5). For the M93C76 and
M93C86, the address is made up of 10 bits for the x16 organization or 11 bits for the x8
organization (see Table 6).
The M93Cx6 devices are fabricated in CMOS technology and are therefore able to run as
slow as 0 Hz (static input signals) or as fast as the maximum ratings specified in “AC
characteristics” tables, in Section 10: DC and AC parameters.
Table 4. Instruction set for the M93C46
Instruction
Description
Start Op-
bit code
x8 origination (ORG = 0)
x16 origination (ORG = 1)
Address
(1)
Data
Required
clock
Address
(1)
cycles
Data
Required
clock
cycles
READ
Read Data from
Memory
1
10
A6-A0 Q7-Q0
A5-A0 Q15-Q0
WRITE
Write Data to
Memory
1
01
A6-A0 D7-D0
18
A5-A0 D15-D0
25
WEN
Write Enable
1
00 11X XXXX
10
11 XXXX
9
WDS
Write Disable
1
00
00X
XXXX
10
00 XXXX
9
ERASE
Erase Byte or
Word
1
11
A6-A0
10
A5-A0
9
ERAL
Erase All Memory 1
00
10X
XXXX
10
10 XXXX
9
WRAL
Write All Memory
with same Data
1
00
01X
XXXX
D7-D0
18
01 XXXX D15-D0
25
1. X = Don't Care bit.
DocID4997 Rev 13
11/33