STM8S103F3M3 Datasheet, PDF (107/117 Pages) STMicroelectronics – Access line, 16 MHz STM8S 8-bit MCU, up to 8 Kbytes Flash, data EEPROM,10-bit ADC, 3 timers, UART, SPI, I²C

STM8S103K3 STM8S103F3 STM8S103F2
Ordering information
Address
.............................................................................................
Contact
.............................................................................................
Phone no.
.............................................................................................
Reference FASTROM code^a .............................................................................................
Preferable format for programing code is .Hex (.s19 is accepted)
If data EEPROM programing is required, a seperate file must be sent with the requested data.
Important: See the option byte section in the datasheet for authorized option byte
combinations and a detailed explanation. Do not use more than one remapping option
in the same port. It is forbidden to enable both AFR1 and AFR0.
Device type/memory size/package (check only one option)
FASTROM device
LQFP32
UFQFPN20
UFQFPN32
TSSOP20
SO20W
4 Kbyte
[ ] STM8S103F2
[ ] STM8S103F2
[ ] STM8S103F2
8 Kbyte
[ ] STM8S103K3
[ ] STM8S103F3
[ ] STM8S103K3
[ ] STM8S103F3
[ ] STM8S103F3
Conditioning (check only one option)
[ ] Tape & reel or [ ] Tray
Special marking (check only one option)
[ ] No [ ] Yes
Authorized characters are letters, digits, '.', '-', '/' and spaces only. Maximum character counts
are:
UFQFPN20: 1 line of 4 characters max: "_ _ _ _"
UFQFPN32: 1 line of 7 characters max: "_ _ _ _ _ _ _"
LQFP32: 2 lines of 7 characters max: "_ _ _ _ _ _ _" and "_ _ _ _ _ _ _"
TSSOP20/SO20: 1 line of 10 characters max: "_ _ _ _ _ _ _ _ _ _"
Three characters are reserved for code identification.
Temperature range
[ ] -40°C to +85°C or [ ] -40°C to +125°C
Padding value for unused program memory (check only one option)
[ ]0xFF
[ ]0x83
[ ]0x75
Fixed value
TRAP instruction opcode
Illegal opcode (causes a reset when executed)
a _{FASTROM code name is assigned by STMicroelectronics.}
DocID15441 Rev 9
107/117