VNQ830-E Datasheet, PDF (1/21 Pages) STMicroelectronics – QUAD CHANNEL HIGH SIDE DRIVER

VNQ830-E
QUAD CHANNEL HIGH SIDE DRIVER
Table 1. General Features
Type
R_DS(on)
I_out
V_CC
VNQ830-E
60mΩ (*) 6A (*)
36V
(*) Per each channel
■ CMOS COMPATIBLE INPUTS
■ OPEN DRAIN STATUS OUTPUTS
■ ON STATE OPEN LOAD DETECTION
■ OFF STATE OPEN LOAD DETECTION
■ SHORTED LOAD PROTECTION
■ UNDERVOLTAGE AND OVERVOLTAGE
SHUTDOWN
■ LOSS OF GROUND PROTECTION
■ VERY LOW STAND-BY CURRENT
■ REVERSE BATTERY PROTECTION (**)
■ IN COMPLIANCE WITH THE 2002/95/EC
EUROPEAN DIRECTIVE
Figure 1. Package
SO-28 (DOUBLE ISLAND)
DESCRIPTION
The VNQ830-E is a quad HSD formed by
assembling two VND830-E chips in the same SO-
28 package. The VNQ830-E is a monolithic device
made by using| STMicroelectronics VIPower M0-3
Technology. The VNQ830-E is intended for driving
any type of multiple loads with one side connected
to ground. Active V_CC pin voltage clamp protects
the device against low energy spikes (see
ISO7637 transient compatibility table).
Active current limitation combined with thermal
shutdown and automatic restart protects the
device against overload.
The device detects open load condition both in on
and off state. Output shorted to V_CC is detected in
the off state. Device automatically turns off in case
of ground pin disconnection.
Table 2. Order Codes
Package
SO-28
VNQ830-E
Tube
Note: (**) See application schematic at page 10
November 2004
Tape and Reel
VNQ830TR-E
Rev. 2
1/21