VNQ690SP-E Datasheet, PDF (1/20 Pages) STMicroelectronics – QUAD CHANNEL HIGH SIDE DRIVER

VNQ690SP-E
QUAD CHANNEL HIGH SIDE DRIVER
Table 1. General Features
Type
R_DS(on)
I_out
V_CC
VNQ690SP-E
90mΩ (*)
10A
36V
(*) Per each channel
s OUTPUT CURRENT PER CHANNEL: 10A
s CMOS COMPATIBLE INPUTS
s OPEN LOAD DETECTION (OFF STATE)
s UNDERVOLTAGE & OVERVOLTAGE
n SHUT- DOWN
s OVERVOLTAGE CLAMP
s THERMAL SHUT-DOWN
s CURRENT LIMITATION
s VERY LOW STAND-BY POWER DISSIPATION
s PROTECTION AGAINST:
n LOSS OF GROUND & LOSS OF V_CC
s REVERSE BATTERY PROTECTION (**)
s IN COMPLIANCE WITH THE 2002/95/EC
EUROPEAN DIRECTIVE
Figure 1. Package
10
1
PowerSO-10™
DESCRIPTION
The VNQ690SP-E is a monolithic device made by
using| STMicroelectronics VIPower M0-3
Technology, intended for driving resistive or
inductive loads with one side connected to ground.
This device has four independent channels.
Built-in thermal shut down and output current
limitation protect the chip from over temperature
and short circuit.
Table 2. Order Codes
Package
PowerSO-10™
Tube
VNQ690SP-E
Note: (**) See application schematic at page 9
October 2004
Tape and Reel
VNQ690SPTR-E
Rev. 1
1/20