VND830AEP-E Datasheet, PDF (1/26 Pages) STMicroelectronics – Double channel high side driver

VND830AEP-E
Double channel high side driver
Features
Type
VND830AEP-E
R_DS(on)
60mΩ⁽¹⁾
1. Per each channel.
I_OUT
6A⁽¹⁾
V_CC
36V
■ DC short circuit current: 6A
■ CMOS compatible inputs
■ Proportional load current sense
■ Undervoltage and overvoltage shutdown
■ Overvoltage clamp
■ Thermal shutdown
■ Current limitation
■ Very low standby power dissipation
■ Protection against loss of ground and loss of
V_CC
■ Reverse battery protection^(a)
■ In compliance with the 2002/95/EC european
directive
PowerSSO-24
Description
The VND830AEP-E is a monolithic device made
using| STMicroelectronics VIPower™ M0-3
Technology. The VND830AEP-E is intended for
driving any type of multiple load with one side
connected to ground.
The Active V_CC pin voltage clamp protects the
device against low energy spikes (see ISO7637
transient compatibility table).
This device has two channels in high side
configuration; each channel has an analog sense
output on which the sensing current is
proportional (according to a known ratio) to the
corresponding load current. Built-in thermal
shutdown and outputs current limitation protect
the chip from over temperature and short circuit.
The device automatically turns off in the case
where the ground pin becomes disconnected.
a. See Application schematic on page 16
Table 1. Device summary
Package
PowerSSO-24
Tube
VND830AEP-E
Order codes
Tape and reel
VND830AEPTR-E
September 2013
Doc ID 11038 Rev 4
1/26
www.st.com
1