VND810PEP-E Datasheet, PDF (1/15 Pages) STMicroelectronics – DOUBLE CHANNEL HIGH SIDE DRIVER

VND810PEP-E
DOUBLE CHANNEL HIGH SIDE DRIVER
Table 1. General Features
TYPE
R_DS(on)
VND810PEP-E 160 mΩ (*)
I_OUT
3.5 A (*)
V_CC
36 V
(*) Per each channel
■ CMOS COMPATIBLE INPUTS
■ OPEN DRAIN STATUS OUTPUTS
■ ON STATE OPEN LOAD DETECTION
■ OFF STATE OPEN LOAD DETECTION
■ SHORTED LOAD PROTECTION
■ UNDERVOLTAGE AND OVERVOLTAGE
SHUTDOWN
■ PROTECTION AGAINST LOSS OF GROUND
■ VERY LOW STAND-BY CURRENT
■ REVERSE BATTERY PROTECTION (**)
■ IN COMPLIANCE WITH THE 2002/95/EC
EUROPEAN DIRECTIVE
Figure 1. Package
TARGET SPECIFICATION
PowerSSO-12
DESCRIPTION
The VND810PEP-E is a monolithic device designed
in STMicroelectronics VIPower M0-3 Technology,
intended for driving any kind of load with one side
connected to ground.
Active V_CC pin voltage clamp protects the device
against low energy spikes (see ISO7637 transient
compatibility table).
Active current limitation combined with thermal
shutdown and automatic restart protects the
device against overload. The device detects open
load condition both in on and off state. Output
shorted to V_CC is detected in the off state. Device
automatically turns off in case of ground pin
disconnection.
Table 2. Order Codes
Package
PowerSSO-12
Note: (**) See application schematic at page 9
Tube
VND810PEP-E
Tape and Reel
VND810PEPTR-E
November 2004
Rev. 4
1/15
This is preliminary information on a new product foreseen to be developed. Details are subject to change without notice.