VND810MSP-E Datasheet, PDF (1/20 Pages) STMicroelectronics – DOUBLE CHANNEL HIGH SIDE DRIVER

VND810MSP-E
DOUBLE CHANNEL HIGH SIDE DRIVER
Table 1. General Features
Type
R_DS(on)
VND810MSP-E
(*) Per each channel
150 mΩ (*)
I_out
0.6 A (*)
V_CC
36 V
■ CMOS COMPATIBLE INPUTS
■ OPEN DRAIN STATUS OUTPUTS
■ ON STATE OPEN LOAD DETECTION
■ OFF STATE OPEN LOAD DETECTION
■ SHORTED LOAD PROTECTION
■ UNDERVOLTAGE AND OVERVOLTAGE
SHUTDOWN
■ PROTECTION AGAINST LOSS OF GROUND
■ VERY LOW STAND-BY CURRENT
■ REVERSE BATTERY PROTECTION (**)
■ IN COMPLIANCE WITH THE 2002/95/EC
EUROPEAN DIRECTIVE
DESCRIPTION
The VND810MSP-E is a monolithic device
designed in STMicroelectronics VIPower M0-3
Technology, intended for driving any kind of load
with one side connected to ground.
Active V_CC pin voltage clamp protects the device
against low energy spikes (see ISO7637 transient
compatibility table).
Figure 1. Package
10
1
PowerSO-10™
Active current limitation combined with thermal
shutdown and automatic restart protects the
device against overload. The current limitation
threshold is aimed at detecting the 21W/12V
standard bulb as an overload fault. The device
detects open load condition both in on and off
state. Output shorted to V_CC is detected in the off
state. Device automatically turns off in case of
ground pin disconnection.
Table 2. Order Codes
Package
PowerSO-10™
Tube
VND810MSP-E
Note: (**) See application schematic at page 9
Tape and Reel
VND810MSPTR-E
March 2005
Rev. 2
1/20