VND600SP Datasheet, PDF (1/18 Pages) STMicroelectronics – DOUBLE CHANNEL HIGH SIDE SOLID STATE RELAY

®
VND600SP
DOUBLE CHANNEL HIGH SIDE SOLID STATE RELAY
TYPE
R_DS(on)
I_lim
VND600SP
30mΩ
25A
V_CC
36 V
s DC SHORT CIRCUIT CURRENT: 25 A
s CMOS COMPATIBLE INPUTS
s PROPORTIONAL LOAD CURRENT SENSE
n s UNDERVOLTAGE AND OVERVOLTAGE
SHUT-DOWN
s OVERVOLTAGE CLAMP
s THERMAL SHUT DOWN
s CURRENT LIMITATION
s VERY LOW STAND-BY POWER DISSIPATION
s PROTECTION AGAINST:
n LOSS OF GROUND AND LOSS OF V_CC
s REVERSE BATTERY PROTECTION (*)
DESCRIPTION
The VND600SP is a monolithic device made
using STMicroelectronics VIPower M0-3
technology. It is intended for driving resistive or
inductive loads with one side connected to
ground. Active V_CC pin voltage clamp protects the
device against low energy spikes (see ISO7637
BLOCK DIAGRAM
10
1
PowerSO-10™
ORDER CODES
PACKAGE
TUBE
T&R
PowerSO-10™ VND600SP VND600SP13TR
transient compatibility table). This device has two
channels in high side configuration; each channel
has an analog sense output on which the sensing
current is proportional (according to a known ratio)
to the corresponding load current. Built-in thermal
shut-down and outputs current limitation protect
the chip from over temperature and short circuit.
Device turns off in case of ground pin
disconnection.
V_CC
INPUT 1
INPUT 2
GND
V_CC CLAMP
LOGIC
Ot1
OVERTEMP. 1
Ot2
OVERTEMP. 2
OVERVOLTAGE
UNDERVOLTAGE
DRIVER 1
PwCLAMP 1
I_LIM1
V_dslim1
Ot1
I_OUT1
K
DRIVER 2
PwCLAMP 2
I_LIM2
V_dslim2
Ot2
I_OUT2
K
OUTPUT 1
CURRENT
SENSE 1
OUTPUT 2
CURRENT
SENSE 2
(*) See application schematic at page 8
July 2004
Rev. 2
1/18
1