VND600PEP-E Datasheet, PDF (1/19 Pages) STMicroelectronics – DOUBLE CHANNEL HIGH SIDE DRIVER

VND600PEP-E
DOUBLE CHANNEL HIGH SIDE DRIVER
Table 1. General Features
TYPE
R_DS(on)
I_lim
V_CC
VND600PEP-E 30mΩ ^(*)
25A
36V
(*) Per each channel
■ DC SHORT CIRCUIT CURRENT: 25A
■ CMOS COMPATIBLE INPUTS
■ PROPORTIONAL LOAD CURRENT SENSE
■ UNDERVOLTAGE AND OVERVOLTAGE
SHUT-DOWN
■ OVERVOLTAGE CLAMP
■ THERMAL SHUT-DOWN
■ CURRENT LIMITATION
■ VERY LOW STAND-BY POWER DISSIPATION
■ PROTECTION AGAINST:
LOSS OF GROUND AND LOSS OF V_CC
■ REVERSE BATTERY PROTECTION (**)
■ IN COMPLIANCE WITH THE 2002/95/EC
EUROPEAN DIRECTIVE
DESCRIPTION
The VND600PEP-E is a monolithic device made
using STMicroelectronics VIPower M0-3
technology. It is intended for driving resistive or
inductive loads with one side connected to ground.
Active V_CC pin voltage clamp protects the device
against low energy spikes (see ISO7637 transient
compatibility table).
Figure 1. Package
PowerSSO-24
This device has two channels in high side
configuration; each channel has an analog sense
output on which the sensing current is proportional
(according to a known ratio) to the corresponding
load current. Built-in thermal shut-down and
outputs current limitation protect the chip from
over temperature and short circuit. Device turns off
in case of ground pin disconnection.
Table 2. Order Codes
Package
PowerSSO-24
Note: (**) See application schematic at page 9
Tube
VND600PEP-E
Tape and Reel
VND600PEPTR-E
May 2005
Rev. 5
1/19
This is preliminary information on a new product foreseen to be developed. Details are subject to change without notice.