VND600-E Datasheet, PDF (1/18 Pages) STMicroelectronics – DOUBLE CHANNEL HIGH SIDE DRIVER

VND600-E
DOUBLE CHANNEL HIGH SIDE DRIVER
Table 1. General Features
Type
R_DS(on)
VND600-E
35 mΩ
I_lim
25 A
V_CC
36 V
Figure 1. Package
s DC SHORT CIRCUIT CURRENT: 25 A
s CMOS COMPATIBLE INPUTS
s PROPORTIONAL LOAD CURRENT SENSE
n s UNDERVOLTAGE AND OVERVOLTAGE
SHUT-DOWN
s OVERVOLTAGE CLAMP
s THERMAL SHUT DOWN
s CURRENT LIMITATION
s VERY LOW STAND-BY POWER DISSIPATION
s PROTECTION AGAINST:
n LOSS OF GROUND AND LOSS OF V_CC
s REVERSE BATTERY PROTECTION (*)
s IN COMPLIANCE WITH THE 2002/95/EC
EUROPEAN DIRECTIVE
SO-16L
DESCRIPTION
The VND600-E is a monolithic device made using
STMicroelectronics VIPower M0-3 technology. It
is intended for driving resistive or inductive loads
with one side connected to ground. Active V_CC pin
voltage clamp protects the device against low
energy spikes (see ISO7637 transient
compatibility table).
This device has two channels in high side
configuration; each channel has an analog sense
output on which the sensing current is proportional
(according to a known ratio) to the corresponding
load current. Built-in thermal shut-down and
outputs current limitation protect the chip from
over temperature and short circuit. Device turns off
in case of ground pin disconnection.
Table 2. Order Codes
Package
SO-16L
VND600-E
Tube
Note: (*) See application schematic at page 9
October 2004
Tape and Reel
VND600TR-E
Rev. 1
1/18