VND5T035AKTR-E Datasheet, PDF (1/31 Pages) STMicroelectronics – Double channel high-side driver with analog current sense for 24 V automotive applications

VND5T035AK-E
Double channel high-side driver with analog current sense
for 24 V automotive applications
Datasheet − production data
Features
Max transient supply voltage
Operating voltage range
Typ on-state resistance (per ch.)
Current limitation (typ)
Off-state supply current
V_CC
V_CC
R_ON
I_LIM
I_S
58 V
8 to 36 V
35 mΩ
42 A
2 µA
■ General
– Very low standby current
– 3.0 V CMOS compatible input
– Optimized electromagnetic emission
– Very low electromagnetic susceptibility
– Compliant with European directive
2002/95/EC
– Fault reset standby pin (FR_Stby)
■ Diagnostic functions
– Proportional load current sense
– High current sense precision for wide range
currents
– Off-state open load detection
– Output short to V_CC detection
– Overload and short to ground latch off
– Thermal shutdown latch-off
– Very low current sense leakage
■ Protections
– Undervoltage shutdown
– Overvoltage clamp
– Load current limitation
– Self limiting of fast thermal transients
– Protection against loss of ground and loss
of V_CC
– Thermal shutdown
– Electrostatic discharge protection
0OWER33/ 
("1($'5
Application
All types of resistive, inductive and capacitive
loads
Description
The VND5T035AK-E is a monolithic device made
using STMicroelectronics^® VIPower^® technology,
intended for driving resistive or inductive loads
with one side connected to ground. Active V_CC pin
voltage clamp protects the device against low
energy spikes.
The device integrates an analog current sense
which delivers a current proportional to the load
current.
Fault conditions such as overload,
overtemperature or short to V_CC are reported via
the current sense pin.
Output current limitation protects the device in
overload conditions. The device latches off in
case of overload or thermal shutdown.
The device is reset by a low level pass on the fault
reset standby pin.
A permanent low level on the inputs and on the
fault reset standby pins disables all outputs and
sets the device in standby mode.
March 2012
This is information on a product in full production.
Doc ID 018942 Rev. 4
1/31
www.st.com
1