VND5E050MJ-E Datasheet, PDF (1/40 Pages) STMicroelectronics – Double-channel high-side driver with analog current sense for automotive applications

VND5E050MJ-E
VND5E050MK-E
Double-channel high-side driver with analog current sense
for automotive applications
Features
Max transient supply voltage
V_CC
41 V
Operating voltage range
V_CC 4.5 V to 28 V
Max on-state resistance(per ch.) R_ON 50 m
Current limitation (typ)
Off-state supply current
I_LIMH
I_S
27 A
2 µA⁽¹⁾
1. Typical value with all loads connected.
• General
– Inrush current active management by
power limitation
– Very low standby current
– 3.0 V CMOS compatible inputs
– Optimized electromagnetic emissions
– Very low electromagnetic susceptibility
– In compliance with the 2002/95/EC
european directive
– Very low current sense leakage
• Diagnostic functions
– Proportional load current sense
– High-precision current sense for wide
currents range
– Current sense disable
– Overload and short to ground (power
limitation) indication
– Thermal shutdown indication
• Protections
– Undervoltage shutdown
– Overvoltage clamp
– Load current limitation
– Self limiting of fast thermal transients
– Protection against loss of ground and loss
of V_CC
– Overtemperature shutdown with auto
restart (thermal shutdown)
– Reverse battery protected (see Figure 29)
PowerSSO-12
PowerSSO-24
– Electrostatic discharge protection
Applications
• All types of resistive, inductive and capacitive
loads
• Suitable as LED driver
Description
The VND5E050MJ-E and VND5E050MK-E are
double-channel high-side drivers manufactured in
the ST proprietary VIPower™ M0-5 technology
and housed in the tiny PowerSSO-12 and
PowerSSO-24 packages. The VND5E050MJ-E
and VND5E050MK-E are designed to drive 12 V
automotive grounded loads delivering protection,
diagnostics and easy 3 V and 5 V CMOS
compatible interface with any microcontroller.
The devices integrate advanced protective
functions such as load current limitation, inrush
and overload active management by power
limitation, overtemperature shut-off with
auto-restart and overvoltage active clamp. A
dedicated analog current sense pin is associated
with every output channel in order to provide
enhanced diagnostic functions including fast
detection of overload and short-circuit to ground
through power limitation indication and
overtemperature indication.
The current sensing and diagnostic feedback of
the whole device can be disabled by pulling the
CS_DIS pin high to allow sharing of the external
sense resistor with other similar devices.
September 2013
Doc ID 15532 Rev 2
1/40
www.st.com
1