VND5E050J-E_09 Datasheet, PDF (1/40 Pages) STMicroelectronics – Double channel high side driver for automotive applications

VND5E050J-E
VND5E050K-E
Double channel high side driver for automotive applications
Features
Max supply voltage
Operating voltage range
Max On-State resistance (per ch.)
Current limitation (typ)
Off-state supply current
V_CC
V_CC
R_ON
I_LIMH
I_S
1. Typical value with all loads connected.
41V
4.5 to 28V
50 mΩ
27 A
2 µA⁽¹⁾
■ General
– Inrush current active management by
power limitation
– Very low standby current
– 3.0V CMOS compatible inputs
– Optimized electromagnetic emissions
– Very low electromagnetic susceptibility
– In compliance with the 2002/95/EC
european directive
■ Diagnostic functions
– Open Drain status output
– On-state open-load detection
– Off-state open-load detection
– Output short to Vcc detection
– Overload and short to ground (power
limitation) indication
– Thermal shutdown indication
■ Protections
– Undervoltage shutdown
– Overvoltage clamp
– Load current limitation
– Self limiting of fast thermal transients
– Protection against loss of ground and loss
of V_CC
– Over temperature shutdown with auto
restart (thermal shutdown)
– Reverse battery protected (see Figure 32)
– Electrostatic discharge protection
PowerSSO-12 PowerSSO-24
Applications
■ All types of resistive, inductive and capacitive
loads
Description
The VND5E050J-E and VND5E050K-E are
double channel high-side drivers manufactured in
the ST proprietary VIPower M0-5 technology
and housed in the tiny PowerSSO-12 and
PowerSSO-24 packages.
The VND5E050J-E and VND5E050K-E are
designed to drive automotive grounded loads
delivering protection, diagnostics and easy 3V
and 5V CMOS-compatible interface with any
microcontroller.
The devices integrate advanced protective
functions such as load current limitation, inrush
and overload active management by power
limitation, over temperature shut-off with
auto-restart and over-voltage active clamp.
A dedicated active low digital status pin is
associated with every output channel in order to
provide Enhanced diagnostic functions including
fast detection of overload and short-circuit to
ground, over temperature indication, short-circuit
to V_CC diagnosis and on & off-state open-load
detection.
The diagnostic feedback of the whole device can
be disabled by pulling the STAT_DIS pin up, thus
allowing wired-ORing with other similar devices.
July 2009
Doc ID 14472 Rev 3
1/40
www.st.com
1