VN771K-E Datasheet, PDF (1/21 Pages) STMicroelectronics – QUAD SMART POWER SOLID STATE RELAY FOR COMPLETE H BRIDGE CONFIGURATIONS

VN771K-E
QUAD SMART POWER SOLID STATE RELAY
FOR COMPLETE H BRIDGE CONFIGURATIONS
Table 1. General Features
Type
R_DS(on)
I_OUT
V_CC
VN771K-E
95mΩ (*) 9A (**)
36V
Note: (*) Total resistance of one side in bridge configuration.
Note: (**) Typical current limitation value.
s SUITED AS LOW VOLTAGE BRIDGE
s LINEAR CURRENT LIMITATION
s VERY LOW STAND-BY POWER DISSIPATION
s SHORT CIRCUIT PROTECTED
s STATUS FLAG DIAGNOSTIC (OPEN DRAIN)
s INTEGRATED CLAMPING CIRCUITS
s UNDERVOLTAGE PROTECTION
s ESD PROTECTION
s IN COMPLIANCE WITH THE 2002/95/EC
EUROPEAN DIRECTIVE
DESCRIPTION
The VN771K-E is a device formed by three
monolithic chips housed in a standard SO-28
package: a double high side and two low side
switches. Both the double high side and low side
switches are made using |STMicroelectronics
VIPower™ M0-3 Technology. This device is
suitable to drive a DC motor in a bridge
configuration as well as to be used as a quad
switch for any low voltage application.
Figure 1. Package
SO-28
The dual high side switches have built-in thermal
shutdown to protect the chips from
overtemperature and current limiter blocks to
protect the device from short circuit. Status output
is provided to indicate open load in off and on state
and overtemperature. The low side switches are
two OMNIFET II types (fully autoprotected Power
MOSFET in VIPower™ technology). They have
built-in thermal shutdown, linear current limitation
and overvoltage clamping. Fault feedback for
thermal intervention can be detected by
monitoring the voltage at the input pin.
Table 2. Order Codes
Package
SO-28
VN771K-E
Tube
Tape and Reel
VN771KTR-E
September 2004
Rev. 1
1/21