VN7007AH Datasheet, PDF (1/37 Pages) STMicroelectronics – High-side driver with CurrentSense analog feedback

VN7007AH
High-side driver with CurrentSense analog feedback for
automotive applications
Datasheet - production data
Features
Max transient supply voltage
Operating voltage range
Typ. on-state resistance (per Ch)
Current limitation (typ)
Stand-by current (max)
VCC 40 V
VCC 4 to 28 V
RON 7 mΩ
ILIMH 100 A
ISTBY 0.5 µA
• Automotive qualified
• General
− Single channel smart high-side driver
with CurrentSense analog feedback
− Very low standby current
− Compatible with 3.0 V and 5 V CMOS
outputs
• Diagnostic functions
− Overload and short to ground (power
limitation) indication
− Thermal shutdown indication
− OFF-state open-load detection
− Output short to VCC detection
− Sense enable/ disable
• Protections
− Undervoltage shutdown
− Overvoltage clamp
− Load current limitation
− Self limiting of fast thermal transients
− Loss of ground and loss of VCC
− Reverse battery
− Electrostatic discharge protection
Applications
• All types of Automotive resistive, inductive
and capacitive loads
• Specially intended for Automotive
Headlamps
Description
The device is a single channel high-side driver
manufactured using ST proprietary VIPower^®
technology and housed in the Octapak package.
The device is designed to drive 12 V automotive
grounded loads through a 3 V and 5 V CMOS-
compatible interface, providing protection and
diagnostics.
The device integrates advanced protective
functions such as load current limitation, overload
active management by power limitation and
overtemperature shutdown.
A sense enable pin allows OFF-state diagnosis to
be disabled during the module low-power mode
as well as external sense resistor sharing among
similar devices.
Table 1: Device summary
Package
Order codes
Tape and reel
Octapak
VN7007AHTR
October 2015
DocID027957 Rev 2
This is information on a product in full production.
1/37
www.st.com